About the Axth 25 in 1 Precision Screwdriver Set

The Axth screw driver kit comes in a nice shipping package. On the back of the package you’ll find some details about what’s inside, when you open it up inside of a nice storage/carrying case, slide off the top, inside you will find the screwdriver handle plus 24 different bits that come standard with the precision screw driver kit.

How to use the Screwdriver set?

Depending on the project you’re working on, remove the handle – it fits nice and firmly in the storage case – so it’s not going anywhere. After removing the handle you will need to choose the appropriate bit for the job at hand.

Using the Precision Screwdriver set with eyeglasses.

We’re going to choose this little flat head screwdriver bit, it is quite small but it’s perfect for working on sunglasses and other electronic gear requiring small flathead screwdrivers. Slide the bit into the handle and you are ready to work on your repair. You simply use the screwdriver to tighten down the screw holding the sunglass arm in place. When you’re done the screwdriver arm will have a nice tight and firm sunglass arm.

When you are done with the project make sure you appropriately remove the screwdriver bit put it back in the slot. If you don’t pay attention to returning your bits after you’re done with the project you can very easily mess the set up and it could get unorganized real quickly. Must Own Tools recommends taking the time to keep your kit organized and stored properly.

On top of the handle there is a piece that spins so it’s easy to rotate the screwdriver while holding the handle and pushing down on the end for firmness. It has a nice ruffed up area half way down the handles so you gain traction with your fingers while spinning the handle.
When it’s time for your next project pick out the bit you need slide it into the end of the handle. We will work on a computer which requires a star screwdriver bit.

Computer Repairs with Precision Screwdrivers

Tighten or remove screws on your computer with the Precision Screwdrivers. Push on the top of the screwdriver to provide a nice firm grip on the screw itself and then you can spin the handle with your other hand or other fingers. The screw will come easily out of the computer, or tighten it down with the same motion just in reverse.

Be cautious about using magnetic screwdrivers on your computers. Most magnetic screwdriver sets do not have enough magnification to harm your computer, just to be sure check the manufacturers specifications.

Be diligent in putting the screwdriver bit back in the storage case.  You want to apply slight pressure on the handle and snap it in place. Be sure to slide the top of the case back on until it locks in place. Now that the case is secure, it will fit perfectly in your backpack, tool kit, briefcase or purse. Suggestions on how to fix your computer.